Residential Control Systems TXB16 Manual do Utilizador descarregar pdf (Página 31)

mControl v2 (Home Edition) User Manual

Page 31

Device Options

If the adapter has been configured as a primary controller, the following Device Management

Options are available:

 Start Add Device – use this button to initiate adding a Z-Wave device to the primary

controller (adapter).

Z-Wave devices may not be able to be added if there were previously associated with another network. In

this scenario, you may try to remove the device and then add the device.

 Cancel Add Device – use this button to abort the process of adding a Z-Wave device to

the primary controller (adapter).

 Start Remove Device – use this button to initiate removing a Z-Wave devices from the

primary controller (adapter).

 Cancel Remove Device – use this button to abort the process of removing a Z-Wave

device from the primary controller (adapter.)

 ID of Device To Replace, Remove or Rediscover – this display window provides a list of

devices in the network, which can be selected for replacement, deletion or rediscovery.

 Replace Failed Node – use this button to replace a failed node. This button deletes the

node entry from the network and adds a replacement device with the address previously

used by the failed device. This is useful because deleting and then adding a device may

not result in the same node addressing within the network.

 Delete Failed Node – use this button to delete a failed node from the network. This button

deletes the node entry from the network.

 Rediscover Node – use this button to rediscover Z-Wave information about the node.

Please note, older adapters/firmware may have problems with unenrolling and then re-enrolling devices.

Please verify your network before adding devices to mControl.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 306 307

Sem comentários

Residential Control Systems TXB16 Manual do Utilizador Página 31